OG Vapes Apollo Replacement Atomizer

The OG Vapes Apollo Atomizer is a replacement for your e-Nail that allows you to enjoy your essential oils and concentrates.
Fully charge the Apollo e-Rig before your first use. The device will pulse red while charging and turn off automatically when complete. Fill the glass with water just above the air-holes. Do not fill the glass while attached to the base. Do not allow water in the lower section. Align the inlet hole on the front of the glass with atomizer. Carefully push the front of the glass into the base then back. Turn the device on/off by clicking the power button 5 times quickly. Click the power button three times quickly to select the heat settings. Use the loading tool to place contents on the bottom surface of the bowl.
Place the carb cap on top of the atomizer. Hold down the button for 3 seconds to initiate heat up. It takes about 30 seconds. Press and hold button anytime to exit. The pulsing light indicates the heat-mode is on. The device has a long beeping tone and the light will flash when it’s ready for you to hit it.
Use a cotton swab to clean the chamber after each use.
Product Features:
Atomizer Replacement
Product Includes:
1 x Atomizer Cover
1 x Ceramic Nail
CALIFORNIA PROPOSITION 65 – Warning: This product contains nicotine, Nicotine is an addictive chemical. A chemical known to the state of California to cause birth defects or other reproductive harm.
Note: Descriptions, specifications, and claims are based on manufacturer information. Information listed and provided are to be used at the sole discretion of the consumer and are not representative of analysis, testing, and verification by Wall Street Distribution and any and all of Wall Street Distribution’s parent and subsidiary companies.